Ga door naar hoofdinhoud

A washer series by Maytag with a low rate of customer satisfaction and a high rate of failure. These washers have the model numbers MVWB300xxx or MVWX300xxx.

212 Vragen Bekijk alle

Maytag washer run problem

I have a Maytag washer that with run fine and fill up but once it fills up it will stop. To get it going again I have to hit the front top right corner of the machine with my hand. Once I do that it starts back up and runs through the cycles perfectly. Any ideas what I should look for? Thank you

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

1 Antwoord

Het nuttigste antwoord

Do you feel like the Fonz when it goes back on again? :)

If it's full of water and not spinning then it's most likely your lid switch is broke/or breaking.

When you're hitting it you're probably knocking it temporarily on and then the machine shakes and it goes off.

Try this:

https://www.youtube.com/watch?v=pghabRPu...

Was dit antwoord nuttig?

Score 1
Voeg een opmerking toe

Voeg je antwoord toe

John DiPerrio zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 258