Ga door naar hoofdinhoud

Repair information and guides for the iPhone 6S released by Apple on September 25, 2015. Models: A1688, A1633

2683 Vragen Bekijk alle

Screen not turning on

After screen replacement my screen won’t turn on. The phone was switched of and the repair was done. When the new screen wasn’t working I tried putting the old cracked one back on it but it didn’t work either. I’ve done lots of screen replacements but have never come across this problem. I have tried everything but cannot find any fixed please help.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
1 Opmerking

I’ve tried using a flashlight too see the screen but I cannot see anything but the phone is turning on because I can hear the noise from charging the phone and it vibrates when putting ot on silent

door

Voeg een opmerking toe

1 Antwoord

Gekozen oplossing

Did you forget to unplug the battery?

Backlight failure is a very common issue on the 6s models in particular because of the 4V pin and the ground pin on the LCD connector being next to each other can can be shorted easily when connecting or disconnecting the screen with the battery plugged in (even with the phone and screen turned off).

Usually you will see a puff of smoke near the screen connector when this occurs.

To confirm backlight failure, turn the phone off and use a flashlight to see if you can see a dim apple logo on the middle of the screen, additionally you could connect the iPhone to a computer and open up iTunes to see if the phone successfully boots up and is detected by iTunes.

To get backlight circuit fixed, that requires someone to do micro-soldering on the phone (basically repairing the backlight circuit and components on the logic board).

I would estimate about $80-$150 for the job to be done.

Was dit antwoord nuttig?

Score 2

3 opmerkingen:

I’ve tried using a flashlight too see the screen but I cannot see anything but the phone is turning on because I can hear the noise from charging the phone and it vibrates when putting ot on silent

door

Then it's either a faulty screen or micro-soldering need to be done on the board at least.

TL:DR - Phone most likely needs to be looked at someone that does micro-soldering to troubleshoot no display / backlight issue if multiple screens have been tested already on the phone.

door

Alright okay, thanks.

door

Voeg een opmerking toe

Voeg je antwoord toe

Haris zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 90