Ga door naar hoofdinhoud

Reparatiehandleidingen en ondersteuning voor afwasmachines.

700 Vragen Bekijk alle

Whirpool Dishwasher start/resume light never goes on.

I recently noticed that my start/resume light on my whirlpool dishwasher never goes on. I did put it into diagnostic mode (123...123...button pushing) but don't see or know how to read codes anyways. I did notice that all lights except the start/resume light go on in diagnotic mode. Is it possible that the start/resume light is out or has a bad connection. The washer is only 2 years old and hasn't had that much use. I also do notice that sometimes there is water in the bottom of the washer which makes me think that the cycle doesn't fully complete sometimes. I can pres drain and it will drain fine so not a clogged drain or tube problem (I've had that in the past:) Any thoughts?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

1 Antwoord

Het nuttigste antwoord

If you were able to get it into the diagnostic mode, and that 'Start/Resume' still did not light - you have a burned out LED. Depending on the model, this can only be fixed by replacing either the control panel or the control board. Repairclinic.com should be able to help with finding that information as well based on your model number.

I see this in a lot of cases where the light is burned out - but the button still works correctly. This is an expensive cosmetic repair if it is still working! Good luck -

Was dit antwoord nuttig?

Score 1
Voeg een opmerking toe

Voeg je antwoord toe

rick zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 8

Altijd: 890