Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Vragen Bekijk alle

Opties

iPhone 6 won't hold a charger after battery replacement

I bought the ifixit iPhone 6 battery repair kit and successfully installed the new battery. My issue is my phone still dies when it reaches around 50% battery life. When i plug it in and it boots back up the battery shows 1-6% on it. This only started being an issue after about a month of using the new battery, although the new battery never let me use my phone to 1%, always dying around 10-15% from the start.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

It could be a poor quality replacement battery. To be certain, use a battery utility, such as coconutBattery (for Mac) or 3uTools (for Windows). It will tell you what the health of the battery is. Anything less than 80% of design capacity will require replacement. After testing the battery, I would contact iFixit Support to see about a replacement.

It is possible that you have an issue on the logic board so if another replacement battery behaves the same way, that is where I would look for the problem.

Was dit antwoord nuttig?

Ja Nee
Score 3

2 opmerkingen:

CoconutBattery says "perfect" and its at 100% capacity (1751/1751 mAh). Is replacing a logic board a complicated/cost effective fix and or even worth doing?

door

The logic board is the phone. You may as well replace the phone. I am suggesting a micro-soldering repair.

door

Voeg een opmerking toe

Opties

maybe the battery is not in good condition.

Was dit antwoord nuttig?

Ja Nee
Score 1
Voeg een opmerking toe

Voeg je antwoord toe

Zachary Kessler zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 119