Repareer je spullen Gemeenschap Winkel

Reparatiehandleidingen en -informatie voor de Nintento Switch Joy-Con controllers.

167 Vragen Bekijk alle

Opties

Replaced joy-con shell; bungled joystick?

I did a shell replacement on my whole Switch, including the body and both joy-cons. Everything went great except for the right joy-con: I must have screwed up the joystick because now it’s permanently sending “joystick right” anytime it’s connected to my unit. The joystick itself looks just fine, it doesn’t look bent. The only thing I can think of is maybe I screwed up the ribbon cable when I plugged it back into the joy-con circuit board.

Has this happened to anybody else? If so, is there a fix? If not, is there a place I can buy a new joystick assembly for the right joy-con?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 3
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

I have a similar issue - try lifting the rubber flap that covers the Joystick guts (just under the stick). Then blast some compressed air into here and move stick blast, move stick, blast. See if that helps. Then run the analogue stick configuration from settings.

Was dit antwoord nuttig?

Ja Nee
Score 1

2 opmerkingen:

How did you get the rubber cap back on? It won't fit in for me.

door

You list it back with two pins it will flap and stay back if done right. A little fiddly but if not you hold while someone else sprays

door

Voeg een opmerking toe

Voeg je antwoord toe

Ben Kreeger zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 5

Afgelopen 7 dagen: 6

Afgelopen 30 dagen: 7

Altijd: 2,473