Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6S Plus that was released on September 25, 2015. Model A1687, A1634

1041 Vragen Bekijk alle

Opties

iPhone Water Damage Repair Help

Block Image

Block Image

Block Image

The iPhone 6s Plus I have has water damage and won't turn on at all.

When charging it, the motherboard does not get hot at all almost like it's not receiving a charge.

It does not respond to iTunes or is recognized at all.

I took all shields off and used 99.9% IPA already.

I have realigned the power management chip of the bottom right side of the back of the board. (It was crooked).

However, a small little chip or capacitor has fallen off in the process (see pictures). How can I reattach this chip? Also which other chips could be responsible for the death of my iPhone with no heat at all?

Thank you for helping out!

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

Well shooting for the Tristar is usually a good go to. Have you tested vcc_main?

Was dit antwoord nuttig?

Ja Nee
Score 3

3 opmerkingen:

I am fairly new to microsoldering so I'm not sure what vcc_main is. Could you clarify?

Also, the small little chip in the first picture is not important?

door

Nevermind, I have found vcc_main and the tristar chip. Will check them out. Thanks.

My only question that remains is what is the purpose of the small chip I knocked off in the first picture?

door

Blurry picture but it looks like a coil not a chip. Re tin the pads and replace it

door

Voeg een opmerking toe

Opties

@smarticles, it is FLDIP_RF, it is a signal filter and yes, important to have micro soldered back on.

Was dit antwoord nuttig?

Ja Nee
Score 3
Voeg een opmerking toe

Voeg je antwoord toe

Diego A zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 159