Ga door naar hoofdinhoud

Repair information and guides for the iPhone 6S released by Apple on September 25, 2015. Models: A1688, A1633

2683 Vragen Bekijk alle

Not charging after screen replacement

So i replaced the screen on an iphone 6s, the phone was brought to me almost dead just flashing battery, put it on charger and it charged to 35 percent. So i proceeded with the repair, so its safe to say the battery would charge before i replaced the screen. Installed new screen, turns on everything fine. But when plugged into charger it shows charging but its not charging the battery. I have ordered a new battery for it to see if that will fix the issue. I have tried a reset by holding down the home button and power button. I know i fully discharged the power aswell before removing the screen. I always hold down the power button before removing screens. Any idea how or what could cause this?

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

2 Antwoorden

Gekozen oplossing

Holding power button is pointless, disconnecting battery and waiting about 5 - 10 seconds is enough to discharge everything.

As for your issue, there could be a few possibilities, you may have knocked something off during repair, or accidentally hit something and damaged it.

You could also have a poor quality screen that drains more power than an original screen.

The problem could of also been there beforehand, it could be a tristar chip issue from cheap cable damage, as tristar can cause the phone to only charge up to a certain percentage and it can also cause the fake charging issue that you're experiencing. :-)

Was dit antwoord nuttig?

Score 1

2 opmerkingen:

after the replacement of the screen, the battery was really low, put on charger and it went to 8 percent. I guess it never went past that. I am guess you have experienced this yourself before. Got the screen from Injured gadgets was 75 for it. I know nothing about micro soldering nor the setup for it. Something that i would like to get into very soon.

door

Yes these are some of the symptoms of tristar chip damage, this would require micro soldering.

door

Voeg een opmerking toe
Het nuttigste antwoord

No need to hold power button after unplugging battery.

You only need to wait 5 seconds after unplugging battery.

Have you tried a another charging port flex cable?

Was dit antwoord nuttig?

Score 2
Voeg een opmerking toe

Voeg je antwoord toe

mikebarkas zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 13

Afgelopen 30 dagen: 58

Altijd: 10,541