Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

The Apple iPhone 5s was announced on September 10, 2013. Repair of this device is similar to the previous models, and requires screwdrivers and prying tools. Available as GSM or CDMA / 16, 32, or 64 GB / Silver, Gold, and Space Gray.

4015 Vragen Bekijk alle

Screen not working properly after replacement

Recently I dropped my phone, and it was really broken and actually even bent a little bit, so I had my friend replace it.

The replacement went well, but it becomes very unresponsive at times... When typing usually it registers the wrong key, screen starts going crazy and tapping everywhere (without me touching it), but it's at random times. Sometimes it works really well and sometimes it just goes ham. For some reason locking the screen and unlocking it fixes it, but not always.

Any solutions? Its driving me crazy when i'm trying to text someone or search up a video on YouTube it just goes crazy as mentioned before.

Beantwoord! View the answer Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

Manta schroevendraaierset

112 bitjes voor elke reparatie.

Upgrade Your Toolbox

Manta schroevendraaierset

Upgrade Your Toolbox

3 Antwoorden

Gekozen oplossing

You could have:

  • an incorrectly installed replacement screen.
  • a poor quality replacement screen.
  • a damaged logic board due to the bent housing

It's hard for us to say, you will have to troubleshoot this and isolate some variables. Try to find a known-good screen or try it in a working phone. Double check your connections and insure the right screws are in the right place. Always disconnect your battery before removing the screen.

If the logic board is still bent or warped, that may also be the problem. Do some tests and get back to us or have it looked at by a qualified repair shop.

Was dit antwoord nuttig?

Score 2


Thank you, I will try your possible solutions.


Voeg een opmerking toe
Het nuttigste antwoord

This is usually due to either a bad screen or a damaged logic board like Minho said probably in the touch screen circuit related area of the board.

This may sound stupid but try putting a tempered glass screen protector and see if the issue still occurs.

I had a iPhone 5 screen replacement done once and it would stop responding to touch input and do ghost touching. I put a tempered glass screen protector on and it has worked perfectly fine afterwards.

My guess is that the aftermarket LCD has it's digitizer touch screen layer too close to the glass probably due to the glue being used being too thin and the only way to get the touchscreen to work fine would be putting on a tempered glass screen protector to increase the distance between the touch screen layer and your hand touching the screen physically so that it does not have issues of it being too close.

Pretty much only aftermarket LCDs have this issue as they are pretty much copy LCDs. Refurbished ones would rarely have this issue depending on the quality of the refurbisher.

Was dit antwoord nuttig?

Score 3
Voeg een opmerking toe

Sometimes these touch failure disapear when you put a screen protector on the front, at least you can try that.

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

anderpeenemaa zal eeuwig dankbaar zijn.

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 153