Rep: 1,6k
12
5
3
Customer brought in an iPad Pro 12.9" with a cracked screen. I replace the screen and soldered the new one on properly 100%. Customer has issues with the dead spot on the screen. So I ordered a brand-new digitizer assembly and install that one. Exact same issue as the first one. Anybody have any suggestions? No apparent damage to the control board and soldering is good. Thanks!
Is dit een goede vraag?
Rep: 1
1
then the controller board is bad, simple
sounds to me like proccess of elimination its the controller board, too much heat, etc can damage a controller board, hope you find a solution.
Was dit antwoord nuttig?
Rep: 61
3
lcd is not ok failure
Was dit antwoord nuttig?
LCD is perfectly fine on both. Ordered from 2 separate manufacturers, dead spot in same exact area.
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 1
Afgelopen 30 dagen: 2
Altijd: 475
Same supplier? Seconds?
door mayer
Different Supplier. LCD is good on both.
door GadgetERService