Ga door naar hoofdinhoud

HP ProBook 4320t manufactured in May of 2010.

4 Vragen Bekijk alle

Can't remove CPU heatsink because two of the screw heads are damaged

I replaced the thermal paste on the CPU and Radeon chip in a 4320s a couple years ago due to over heating causing shutdown on boot which fixed the issue.

It's happening again but this time I can't remove the heat sink because two of the screws holding it in place are damaged and won't turn no matter what screwdriver I try. The driver just spins in the head of the screw.

Any advice would be greatly appreciated.

Thanks in advance!

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

1 Antwoord

Have you tried these:http://www.amazon.com/Alden-8440P-Grabit...

Or use a round disc bit to carefully grind a line in the screw with a dremel so the screwdriver will grip?

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Zayn zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 11

Altijd: 491