Ga door naar hoofdinhoud

Cobra 29 LTD Classic. 2-way 40 channel CB radio. Features antenna warning indicator, SWR calibration, instant Channel 9, PA capability, dimmer control, switchable noise blanker and RF gain.

8 Vragen Bekijk alle

My rx/tx light turns red

When I key my mic the rx/tx light turns red. When I unkey it turns back green. I also cannot recieve anything coming in nor can I get out. Please let me know what you think

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 5
1 Opmerking

Mine does the same thing but no antenna light

door

Voeg een opmerking toe

6 Antwoorden

Het nuttigste antwoord

Your tx/rx light should turn red when you transmit and be green all other times. Your ant light should not light up unless the swr is higher than 3.0; then there is a problem. A common reason for the ant light to light up is that the antenna is not grounded properly.

Check out this page from Firestik for more information on swr and cb's.

If your ant light is on when you transmit, stop using the radio and fix the swr. You will ruin the radio.

Good luck and enjoy your cb radio!

Was dit antwoord nuttig?

Score 2

1 Opmerking:

the green light is suppose to be on whe cb is turned on .and red when keyed up.

door

Voeg een opmerking toe

first thing first, check the antenna RF cable

Was dit antwoord nuttig?

Score 0

1 Opmerking:

Mine does the same thing but my ant does not light up when i key the mic.

door

Voeg een opmerking toe

My RX/TX turns red when I transmit as expected, Have no problem transmitting or receiving, My SWR as Advertised and Antenna light stays off, RX/RT light is green until transmit, Make sure that NB-ANL/ANL OFF

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

From what I was reading the NB-ANL/ANL help filter out the noise from the ignition system and other working parts of the vehicle that give off background noise. So, why do I turn this off??

Was dit antwoord nuttig?

Score 0

1 Opmerking:

I wouldn’t turn off the NB/ANL. It filters out a lot of noise.

door

Voeg een opmerking toe

Ok sorry don't have an answer I have another question, my rx/tx red when I key up like it's supposed to, but I have mine on cal to calibrate it but the needle doesn't move to cal ... it doesn't move at all for that matter ... what gives !!?

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

To calibrate it you have to have it on ch 1 and ch 40

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Jake Harris zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 17

Afgelopen 7 dagen: 119

Afgelopen 30 dagen: 597

Altijd: 40,647