Rep: 25
1
When reconnecting the display data cable to the logic board on an EMC 2428, is there a trick to lining it up correctly? I assume that the connection is made by inserting the male cable to the female socket on the logic board by sliding it towards the top of the machine (the reverse of the disconnection), yes?. But I cannot get it to seat in the socket. I would hate to damage it.
Is dit een goede vraag?
Rep: 479,3k
35
329
971
The only issue one faces is putting the plug in backwards. You may want to take some colored tape to mark across the connector & cable to help remind you which face is outwards.
The alignment is straight in and the wire bail holds the connection.
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 1
Altijd: 271
