Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 Plus that was released on September 19, 2014. Model: A1522, A1524

1525 Vragen Bekijk alle

Opties

Replaced digitizer, but touch stopped working after a while.

Replaced a broken digitizer on my iPhone 6 plus, following this guide iPhone 6 Plus Vervanging van het LCD-scherm en de digitizer Used the phone with no problems a whole day, then the touch stopped working.

I've reconnected all the connector cables, worked almost a whole new day, then stopped working again. If i turn the device off, and on again the touch works for like 5 minutes before it stops working again.

Any Ideas on how this problem can be resolved?

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 1
1 Opmerking

Did you find any solutions or answers?

I've been repairing phones for 22 years and I have seen this on an iPhone 6 and 6+ now. I only replace with real OEM screens assemblies, and the the screens are tested on other iPhones and they still work fine. But on these two the digitizers, much like the OP, stop working after a minute or two. There is something going on, maybe a digitizer module?

door

Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

Sounds like you may have bought a faulty LCD, I would get it exchanged, that should solve it.

Was dit antwoord nuttig?

Ja Nee
Score 1
Voeg een opmerking toe

Opties

Touch input all jacked up after multiple screen replacement attempts

^try this maybe. It's working for me.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Voeg je antwoord toe

ca2pedersen zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 1

Altijd: 452