Repareer je spullen Gemeenschap Winkel

Apple released the slimmed-down, buffed up iPad Air on November 1, 2013 in a choice of Space Gray or Silver. It packs the custom A7 processor and ships in 16, 32, 64, and 128 GB configurations.

577 Vragen Bekijk alle

Opties

Left Side of LCD has shadows/lines after screen repair?

Hey guys,

I've had this issue once or twice now and basically after replacing the glass on an iPad Air, the left side of the LCD has weird shadows going down the side of it. Not sure what caused it as I'm always very careful throughout the repair (expensive devices!) but just wanted to check with the iFixit community to see if anyone had some insight here.

I did a quick search and read about possible firmware issues, although this seemed to be for a different issue than what I'm having.

I'll try to get a picture uploaded soon.

Thanks for any help!

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 1
Voeg een opmerking toe

4 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

I also have this issue. Replaced the LCD and the lines/shadows are still present. Any insight would be appreciated.

Was dit antwoord nuttig?

Ja Nee
Score 1
Voeg een opmerking toe

Opties

Hello loosen the screws this puts pressure on the lcd when to tight and can cause shadows hope this helps..

If screen was grand before fitting and there's a problem after its never firmware issues but the repairs fault

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Opties

I have the same defuse squarish pattern up the entire left side. I sent it back thinking it was a manufactures defect only to have a replacement one do the same thing. It has no pressure behind it. It's not even screwed down. Appreciate any help.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Opties

Had the same issue, also still present when the screws were not secured. I was thinking it could have been the connector ribbon as I pulled the edge up a bit when trying to take the connector plate off it (I didn't rip the connector but it just pealed at bit from the connection piece), but not certain.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Voeg je antwoord toe

jon zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 14

Altijd: 1,711