Ga door naar hoofdinhoud

Released June 2012, Model A1278. Intel processor with Turbo Boost

1528 Vragen Bekijk alle

MagSafe Sticker / adhesive

Hi,

since my Macbook is fully disassembled I decided to clean the ports and hubs etc.

They are REALLY dirty.

I started with the MagSafe . So I disconnected the MagSafe Board from the logic board and started to rub with a Q-tip and 99% Isopropanol.

But immediately the sticker came off.

Do you know where I can find a replacement or whatever

Block Image

and Q-tips are a bit too big for the USB Hub etc . Does anyone know a smaller alternative?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0

Commentaar:

Quick follow up on this question: Is there any danger using a mac without this plastic part?

door

Voeg een opmerking toe

1 Antwoord

AFAIK there is no source for small parts like that. (You could try to pick up a damaged unit from e-bay but you'd still be in the same place... removing and reapplying the insulator) If you can't put some spray/brush adhesive on it you could try some double sticky tape.

You could also custom cut an INSULATOR out of electricians tape.

If this answer is acceptable please remember to return and mark it.

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Buco Escobar zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 368