Rep: 17
1
I replaced the digitizer LCD assembly and there are 2 thin lines running down the length of the phone about 1/4 inch apart. (on the right side of the phone running from top to bottom) In between the lines, the touchscreen doesn't work. Is this a bad part or a connection problem?
Thanks,
Karen
Is dit een goede vraag?
Rep: 383
5
2
I see this all the time. Try re-seating the connectors. Sometimes they seem to be all the way in but are not. That fixes it most of the time. If it doesn't then yes, you have a defective part.
Was dit antwoord nuttig?
Thanks, will do!
Rep: 79
6
5
also make sure your wearing esd gloves or wrist strap, ive killed a couple of display assemblies from shocking them but none since ive gone the glove method :)
Was dit antwoord nuttig?
Rep: 433
5
6
1
As PDM says, reconnect the connectors, and also disconnect the battery to do e power cycle. Also check for dust and dirt in the connectors on the motherboard :-)
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 1
Altijd: 110
