Sixth iteration of Apple iPhone, announced on September 12, 2012. Repair of this device is similar to the previous models, requiring screwdrivers and prying tools. Available as GSM or CDMA / 16, 32, or 64 GB / Black or White.

3295 Vragen Bekijk alle

Backlight issue => bad connector screen solderings?

Hello,

I get an iphone 5 which go into some water (red sticker)

Block Image

Block Image

All is working except the backlight which works but at a low level so to determine if it was a problem from the motherboard or the backlight itself, I put another working screen on it and.... the same thing however when I test it the screen wasn't in its compartiment so I can slightly moved the screen (and the connector is a little affect to this action too) and the backlight is directly affect; more bright or less depend on the orientation of the screen.

So I looked closely on the screen connector and it seems that the screen connector is badly solder on 4 pins (judge by yourself thanks to my pictures), can you tell me or confirm that these pins are used by the backlight ? or just send me the scematics of this chip

Thanks

Beantwoord! View the answer Dit probleem heb ik ook

Is dit een goede vraag?

Score 4
Een opmerking toevoegen
Verspreid de kerstsfeer
Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
Verspreid de kerstsfeer
Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12

3 Antwoorden

Gekozen oplossing

Most likely problem = short on backlight coil.

Your backlight filters are not the components that are burned/corroded in your picture, but they are near--you should replace them and backlight coil.

You will certainly have corrosion under those shields--desolder and clean.

Jessa

Yes those pins are bad---and so are your backlight filters--i circled them for you. You need to get all that fixed up if you want your display to work---and given that you have obvious corrosion in the areas you can see, I would bet that you would also be highly likely to have corrosion in the areas you can't see under the EMI shields covering 90% of the board. Get them off, get everything cleaned, replace all your damaged components---otherwise you'll have a dead phone soon enough---that's just the way it seems to go.

jessa

Block Image

Was dit antwoord nuttig?

Score 8

Commentaar:

Thanks for your reply

I think I didn't explain my problem right... when I inclinated the front panel (so included the backlight) which is not in its final emplacement like on step 5-6 of this guide

iPhone 5 Teardown

Also without the shield of the front panel connector then the backlight worked time to time it depends how I inclinated the screen that's why it can't be a problem with chips, components...

Can you confirm that these pins are bad solder ? (I have another iphone 5 board and pins are better solder than this)

Also can you tell me if these pins are used by the backlight or just send me the schematics so I can find it by myself

Thanks for all

door

Yes you're right but since it still works, I will replace them later ofr the moment I just want it to work normally ....

So do you have schematics or just tell me if these pins are used by the backlight ?

Thanks again for all

door

Yes they are and so are the filters.

door

Finally I just put on my brain and follow the filters tracks to the connector...

Anyway I just resolder these pins and.... voila

It works like a sharm however filters are waiting for my soldering iron

door

Last question: could you give me the model of each filter (coil ? capacitor ?) and also tell me relative to the picture of jessa which one is

Thanks

door

3 commentaren meer tonen

Een opmerking toevoegen

Those are all filters with the same values. FL24, FL25, and FL26 are 240OHM 0.2A 0.8OHM ferrite beads. They are available at places like this. Hope this helps, good luck.

Block Image

Was dit antwoord nuttig?

Score 4

Commentaar:

Thank you so much

door

Een opmerking toevoegen

Hey guys just confirming, FL24 is the 240 ohm resistor?

Thanks guys.

Neil

Was dit antwoord nuttig?

Score 0
Een opmerking toevoegen

Voeg je antwoord toe

bigboss59400 zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 Uren: 2

Afgelopen 7 Dagen: 17

Afgelopen 30 Dagen: 55

Altijd: 18,112