Repareer je spullen Gemeenschap Winkel

Fourth generation of iPad, released November 2, 2012, available in 16, 32, or 64 GB models. Model Number A1458

218 Vragen Bekijk alle

Opties

I mistook the home button ribbon cable connector

I have broken off the square 5 wire connector next to the home button ribbon cable, and all the soldered leads are no longer attached. How to repair?

I have attached two pictures from the guide. I mistook the connector as the picture was a little too small to see, only after "prying up the flap" did I discover I pried up the soldered connector.

Is this repairable or have I junked my new iPad 4th ten pride and joy?

Here are pictures where the connector is shown as right next to the cable connector…

Block Image

Block Image

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 1
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste

Opties

The connector can be replaced but the leads may need to be re-routed. It is a difficult repair, you could ruin it further if not done carefully

Was dit antwoord nuttig?

Ja Nee
Score 0

1 Opmerking:

I just found a repair service who will solder a new connector to my logic board for $50 plus shipping. Will advise once I have it back in house.

door

Voeg een opmerking toe

Voeg je antwoord toe

Al Taylor zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 426