Ga door naar hoofdinhoud

Model No. A1367 / 8, 16, 32, or 64 GB capacity

913 Vragen Bekijk alle

Cannot connect digitizer to logic board

I was able to complete this guide: iPod Touch 4th Generation Front Panel Replacement

But I am just unable to connect the first connector to the logic board. I can't properly gauge where it fits, given the limited space, and poor visuals. How would you recommend I go about this? Would I be better off removing more components from the ipod touch so I can more easily connect the connector?

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score -1
Voeg een opmerking toe

1 Antwoord

Gekozen oplossing

Try to get the mother board up from the chassis as much as possible but watch out for the ribbon cable. I usually try to line up the copper tape with the silver box on top of the connector then pinch the connector into place. Be patient and persistent, it will get in there.

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Tyler Montney zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 149