Ga door naar hoofdinhoud

Model A1001 or A1025 / 667, 800, 867, or 1.0 GHz G4 processor

50 Vragen Bekijk alle
Vraag afgerond

To replace a 667mhz G4 PowerBook display and hinges

Hi, Can I use the lid and hinges from a G4 400mhz or 500mhz to replace the lid and hinges on my 667mhz? the right hand hinge on the PB has just ripped the lid apart after just over 7 years of good service. Display is still ok. But would like to replace hinges as per advice on this website.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

3 Antwoorden

Gekozen oplossing

You can use the hinges and the lid of the Ti VGA display but the VGA LCD screen wont work on your DVI Titanium.

Was dit antwoord nuttig?

Score 3
Voeg een opmerking toe

Disassemling a PB G4 Titanium screen is quite a pain, since lid and bezel are glued together. Good photoguide on the bookyard.

And, no, I don't have a connection to them, other that I sometimes buy a few nitbits from them.

Was dit antwoord nuttig?

Score 2
Voeg een opmerking toe

I'm not certain about the swap but perhaps these parts will work for you. Good luck Ralph

http://cgi.ebay.com/Apple-PowerBook-G4-1...

Was dit antwoord nuttig?

Score -1

2 opmerkingen:

Not the good hinges Ralph. Jim has a PowerBook Titanium...

door

Thanks for the response, but I'm none too sure where this leaves me. I don't want to attempt gluing or separating the hinges from the lid so does that suggest I need to find a 667 lid to match my 667 PB?

door

Voeg een opmerking toe
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 1,842