Rep: 71
5
9
I recently installed a motherboard in my 667 Onyx.
When the fan ran on the old board it was loud enough to hear. This one I can't tell if the faint sound is just the HD spin or a quieter fan. Does the fan always run or only when it gets hot enough? I sure would like to not tear the Onyx down again.
Is dit een goede vraag?
Rep: 685,2k
3,4k
1,1k
2,6k
You can get this Fan Control software to do the job: http://www.macupdate.com/info.php/id/250...
Was dit antwoord nuttig?
+ Ralph
Rep: 71
5
9
This a thanx and a comment to Mr. Mayer.
I almost bought the Fan Control software as you suggested. But the price is confusing, $9.99 or 14.99?
Anyway, I took one last shot at activating the fan. I took an 8X10 jpg and Photoshopped the resolution up to 1600 dpi. In less than a minute the fan kicked in with an audible spin.
I am going to download the Fan Control utility.
Thanx again.
Crocdog
Was dit antwoord nuttig?
Rep: 63
3
6
1
I hope you have luck with the G4FanControl. I used it just fine on a 1.67ghz Alum. PowerBook G4, won't work on any DVI, or ANY Titanium model I know of. I've seen other complaints about Fabrizi's "G4FanControl" not working on Titanium models. For that matter, her official site has complaints, just read ALL the testimonials.
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 0
Altijd: 1,834
