Repareer je spullen Gemeenschap Winkel

Repair information and guides for the fifth generation of iPhone. Model: A1387

2193 Vragen Bekijk alle

Opties

iPhone 4s Battery connector missing solder pad 3 pad from the left?

I have an iphone 4s and my battery connector broke while changing the screen I have soldered 3 or 4 back to the logic board. The third solder pad from the left is missing and i read that you can use a single strand cooper wire to bypass the missing solder pad. Where does the bypass wire need to go? I know it needs to go the circuits in from of the connector but which one does it need to be connected to? Sometimes the iphone will load up with the apple boot logo then restart and sometimes it will load up saying the iphone has it 100% percent and other times it will load up saying it has 2% but the fully charged plugged symbol is showing please help

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 1
Voeg een opmerking toe

3 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

http://cellenuity.com/wp-content/uploads...

http://www.cyberdocllc.com/new-tested-so...

Was dit antwoord nuttig?

Ja Nee
Score 2

1 Opmerking:

2nd pin goes to 2 places ? So 2 single strand copper wires should work

door

Voeg een opmerking toe

Opties

Courtlandt21, see if the attached image will help. No.3 wire connects to the resistor (labelled as A for you) and capacitor (labelled B for you) and you need to bridge the resistor (A)

Block Image

Hope this helps, good luck.

Was dit antwoord nuttig?

Ja Nee
Score 1

1 Opmerking:

hey, what if the second pad is gone

door

Voeg een opmerking toe

Opties

I know this is old but I am having the same problem, solder pads 2,3 &4 missing from the battery connector

Can you double check your post please Turkey,.. or the schematics at least, in the picture it has pin 4 going to ground but I have just got my hands on some schematics and from my understanding pin 4 goes to C294 aswell as ground

From my understanding I need to make jumpers as pictured in my upload ?

We've spoke before via email, I was asking you for advice, not really done any board work since then, this is the 1st "big job" in a long time, any help much appreciated as always

Update (06/15/2016)

Block Image

forgot to put the picture in

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Voeg je antwoord toe

Courtlandt21 zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 3,766