Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: Ali Bibi ,

Titel:

Proximity sensor, lightning port and cellular not working all at once.

Tekst:

+Update: I disconnected the earpiece part of Face-ID and run the phone without it everything else works fine now. I would probably try replacing that part to regain speaker functionality.
+
+
+
One day my iPhone X started to have a lot of issues at once:
* Boot-loop if battery is empty, with a new battery I got it to boot and backed up my data but there are other issues
* Lightning port doesn’t work most of the time and even when it shows charging, it doesn’t really charge. A wireless charger works but very slowly.
* iPhone reboots randomly sometimes after only 3 minutes and sometimes after a few hours.
* Face-ID doesn’t work after some digging I found out the proximity sensor doesn’t work.
* Taptic engine doesn’t work, could this be due to a faulty lightning connector assembly?
* Cellular doesn’t work
* The first panic-full log says: “AOP NMI FIQ - pc=0x0106bb9a - rtk_ep_work(0) - watchdog timeout: No response in over 20 sec.“
* All other logs say: “sleep/wake hang detected“
-
From my understanding, the first crash and Face-ID issues could be due to a faulty earpiece flex cable and the other reboots as well as lightning port and taptic engine issues could be due to a faulty lightning connector assembly. However I still have no explanation for why cellular doesn’t work. Finally is it possible that 2 different flex cables fail at once? Is a fault in the logic board more likely?

Apparaat:

iPhone X

Status:

open

Origineel bericht door: Ali Bibi ,

Titel:

Proximity sensor, lightning port and cellular not working all at once.

Tekst:

One day my iPhone X started to have a lot of issues at once:

* Boot-loop if battery is empty, with a new battery I got it to boot and backed up my data but there are other issues
* Lightning port doesn’t work most of the time and even when it shows charging, it doesn’t really charge. A wireless charger works but very slowly.
* iPhone reboots randomly sometimes after only 3 minutes and sometimes after a few hours.
* Face-ID doesn’t work after some digging I found out the proximity sensor doesn’t work.
* Taptic engine doesn’t work, could this be due to a faulty lightning connector assembly?
* Cellular doesn’t work
* The first panic-full log says: “AOP NMI FIQ - pc=0x0106bb9a - rtk_ep_work(0) - watchdog timeout: No response in over 20 sec.“
* All other logs say: “sleep/wake hang detected“

From my understanding, the first crash and Face-ID issues could be due to a faulty earpiece flex cable and the other reboots as well as lightning port and taptic engine issues could be due to a faulty lightning connector assembly. However I still have no explanation for why cellular doesn’t work. Finally is it possible that 2 different flex cables fail at once? Is a fault in the logic board more likely?

Apparaat:

iPhone X

Status:

open