Ga door naar hoofdinhoud
Help

Origineel bericht door: jostewcrew ,

Tekst:

'''Justin Ray'''  … without a schematic to know how those pins are functioning on the attached board, either advise is sound enough. If it was a pin that was not connected/functional or even a ground pin that isnt required for operation, you could leave it off. Since this is the easier of the two, i would try this first.

As far as gluing, not sure if it was actual glue being recommended or just a loose euphemism for making a solder joint to reattach the pin to the board it was adhered to. glue is not conductive and probably would just snap off again once pressure to reattach the connector was applied. would need to try and join these with a jumper wire or just a solder joint. Either way, youre looking at extremely tedious work.

Status:

open