Ga door naar hoofdinhoud
Help

Origineel bericht door: orbatos ,

Tekst:

Pardon if this seems too old to resurrect, but those are almost definitely '''#6-32''' UNC screws, i.e. '''UTS''' '''#6''' (0.1380  inches) and 32 TPI (Threads Per Inch). In order to tap screw holes this should be all you need.

In this case the screws have a T8 head fashioned to provide the hard drive with a set of studs when installed to hold it in place.

In addition to #6-32, Metric M3 Fine pitch screw is often used for mounting SSDs, optical media drives and various other things.

The typical length of case/hard drive screws is around 7/16”, but there is some variation for differing mounting brackets and shock reduction designs.

Status:

open