Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Help

Deze versie is geschreven door: Jovany ,

Tekst:

I have nearly the same problem. I’ve changed the inlet water solenoid valve, but that didn’t help at all.
 
I then removed the bottom propeller and screen only to find a lose spring washer at the bottom of the pan. Ended up to be cracked/broken plastic arm that suppose to lift the drain flapper. As it was broken it couldn’t lift and the water never drain, so the machine wasn’t functioning as it should.
 
Ordered the “unobtainable” arm and should be able to try the repair in a week.
 
UPDATE: The plastic arm is not available from any seller! I was forced to JBWeld it and install it only to find that the solenoid that drives it popped out it’s core and was not functioning.
 
After installing the solenoid core back and connecting the connecting rod to the lever the washer works as new! It fills and drains hassle-free!

Status:

open

Origineel bericht door: Jovany ,

Tekst:

I have nearly the same problem. I’ve changed the inlet water solenoid valve, but that didn’t help at all.

I then removed the bottom propeller and screen only to find a lose spring washer at the bottom of the pan. Ended up to be cracked/broken plastic arm that suppose to lift the drain flapper. As it was broken it couldn’t lift and the water never drain, so the machine wasn’t functioning as it should.

Ordered the “unobtainable” arm and should be able to try the repair in a week.

Status:

open