Ga door naar hoofdinhoud
Help

Origineel bericht door: jayeff ,

Tekst:

Hi,

As you know water and electronics and electricity are not a good mix.

''The water causes corrosion and provides circuit paths for the electricity which were not in the camera's operating design and could damage the components.''

''First '''do not turn on your camera''' and then you need to '''remove the battery as soon as possible''' from the camera'' to minimize any further damage.

Then you need to dis-assemble the rest of the camera and  clean ''all the affected parts'' using '''Isopropyl Alcohol 90%+''' (available from electronics parts stores) to remove all traces of corrosion and water. Do not use "rubbing alcohol" as in some cases this is only 70% IPA or less, can contain scents and is not as effective. If you do use it, check the label to verify the  amount of IPA.

Here is a link that describes the process.

[[Electronics Water Damage]]

As always with electronics, especially surface mounted PCBs be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the boards.

Hopefully after you have done all this the camera ''might'' possibly work correctly again.

Here is a link to the ifixit guide(s) for repairing your camera, which may be of some help. [[Topic:Samsung TL220]]

Here’s a link to a [https://www.youtube.com/watch?v=4q5ftVR2-6s|video], which shows how to dis-assemble your camera, which may also be of some  help.

Status:

open