My best idea? Emulate the Qi chargers for android
# Figure out how to connect to 30 pin connector to charge idevices (which connection)
# get Cheapo qi receiver and remove USB / Lightning connection
# Connect wires to old 30 pin connector to correct QI receiver wires to charge.
# Plug in and make sure it works.
# get soft plastic case for Idevice
# plug 30 pin in then while holding idevice upside down so the receiver is flat to back, slip cover over receiver.
# put iphone down on qi charger to test
# This has benefit of not damaging inside of idevice.
Hardest part is if the 30 pin doesn’t work correctly. I think you may be able to get an lightning to 30 pin adapter, open it up and using a lightening based qi receiver, wire it directly. The best part of this is it all should work and be testable before you even start the project
I have some old powermat based iphone 4 wireless charger cases that work but, I don’t want powermat and Qi charging stations all over the place. I want qi only because all my android devices use that