Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: Dan ,

Tekst:

You’ll need to cut a new slot in the stub if it still has some height.height using this: [https://shop.brownells.com/gunsmith-tools-supplies/general-gunsmith-tools/files/screw-equalling-file-1-012-sku249109118-5743-13640.aspx?cm_mmc=PPC-_-Itwine-_-Google-_-249-109-118&gclid=Cj0KCQiArqPgBRCRARIsAPwlHoWUPgpe03KURkgZZ9sBjpJKlQEsHdZ_Lze9mafn9WQCaSmBHEF1818aAk_xEALw_wcB|Screw Slot Files]
You’ll need to cut a new slot in the stub if it still has some height.height using this: [https://shop.brownells.com/gunsmith-tools-supplies/general-gunsmith-tools/files/screw-equalling-file-1-012-sku249109118-5743-13640.aspx?cm_mmc=PPC-_-Itwine-_-Google-_-249-109-118&gclid=Cj0KCQiArqPgBRCRARIsAPwlHoWUPgpe03KURkgZZ9sBjpJKlQEsHdZ_Lze9mafn9WQCaSmBHEF1818aAk_xEALw_wcB|Screw Slot Files]
 
From the image its hard to tell if you snapped off the screws head or not.
 
If you snapped off the head and its flush with the threaded stand off you’ll need to get a left twist drill and using a reverse drill carefully drill the screw out.
 
In either case you’ll need to take the battery out and carefully mask off the area so the metal filings don’t short out your logic board.

Status:

open

Origineel bericht door: Dan ,

Tekst:

You’ll need to cut a new slot in the stub if it still has some height.

From the image its hard to tell if you snapped off the screws head or not.

If you snapped off the head and its flush with the threaded stand off you’ll need to get a left twist drill and using a reverse drill carefully drill the screw out.

In either case you’ll need to take the battery out and carefully mask off the area so the metal filings don’t short out your logic board.

Status:

open