Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: Timm Simpkins ,

Titel:

Is there a board view for the iPad 5 LTE?

Tekst:

I went to replace the tristar chip on this board, and accidentally knocked off a component next to tristar.  I couldn’t find the component to put it back, and I didn’t pay enough attention before hand to know what it was, nor do I have a donor board for this model.  I decided to test if it might have been a filter capacitor or something, and reassembled things, just to get a boot loop, so I need to find out what the component was and replace it.  It was likely either a resistor or a diode, but I’m not sure.[br]

[br]

ZXW tool and Easy Draw both have schematics and board views for the 4th generation iPad and the iPad Air/2 models, but they don’t seem to have the 5th gen schematics and board view.  On the other models, it appears that there are a couple zero ohm resistors in that area, but things look different enough I don’t want to just try it without more information.[br]

[br]

Is there a board view for the iPad 5 so I can figure out what the components are surrounding tristar on this board?

Apparaat:

iPad 5 LTE

Status:

open

Goedgekeurd antwoord:

517110

Origineel bericht door: Timm Simpkins ,

Titel:

Is there a board view for the iPad 5 LTE?

Tekst:

I went to replace the tristar chip on this board, and accidentally knocked off a component next to tristar.  I couldn’t find the component to put it back, and I didn’t pay enough attention before hand to know what it was, nor do I have a donor board for this model.  I decided to test if it might have been a filter capacitor or something, and reassembled things, just to get a boot loop, so I need to find out what the component was and replace it.  It was likely either a resistor or a diode, but I’m not sure.[br]

[br]

ZXW tool and Easy Draw both have schematics and board views for the 4th generation iPad and the iPad Air/2 models, but they don’t seem to have the 5th gen schematics and board view.  On the other models, it appears that there are a couple zero ohm resistors in that area, but things look different enough I don’t want to just try it without more information.[br]

[br]

Is there a board view for the iPad 5 so I can figure out what the components are surrounding tristar on this board?

Apparaat:

iPad 5 LTE

Status:

open