Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: Little Sulinder ,

Tekst:

tools required:
+
+
a double edge razor so squeeze between the base plate and the body
+
+
a hairdryer (safer than hot air rework station)
+
+
a plastic knife to pry
+
+
a t4 screw driver
-4-5 hours of
+
+
+4-5 hours of work
+
+
+
+
+
+
+
+double edge razor is also really effective at removing leftover double sided tape.
+
+
+
+when prying, appropriate heat and patience will make sure that you dont bend the backplate. both batteries are surrounded by double sided tape.
+
+
+
+the usb board overlaps the gpu board, and needs to be pulled back, gently, amd then lift around 45 degree, and out. then take the gpu board out.
+
+
+
+screws were alot, but no hidden ribbons that you can rip out (but 2 lvds at the top that can be cut if you use anything sharp, hence the plastic knife).
+
+
+
+
+
+
+
+IF YOU ARE APPLYING LIQUID THERMAL, USE LESS THAN 1ML “ON A COTTON SWAB/Q-TIP" AND USE THE QTIP TO APPLY. “DO NOT APPLY DIRECTLY TO THE GPU DIE" even a tiny 0.5ml drop on swab was enough to cover the die. even lesser was needed to cover the heatsink.

Status:

open

Origineel bericht door: Little Sulinder ,

Tekst:

tools required:

a double edge razor so squeeze between the base plate and the body

a hairdryer (safer than hot air rework station)

a plastic knife to pry

a t4 screw driver

4-5 hours of

Status:

open