Ga door naar hoofdinhoud
Help

Origineel bericht door: Minho ,

Tekst:

Those caps are on the PP_GPU line and it is a very low resistance line, typically in the 10-20 Ohm range. Most meters will "beep" when set to continuity mode with that kind of resistance.  So unless you are measuring <1 Ohm, I would say the readings are normal.

You don't really say what the original issue/problem was so I will just say that if you have fast battery drain, try a known-good battery first and then remove all peripherals and test them individually. If the drain occurs even with just the logic board (with a known-good battery and Lightning port), then you need to measure all of the PMIC & BB PMU lines.

Status:

open