Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Help

Deze versie is geschreven door: mayer (stem details) ,

Titel:

Whirlpool Dishwasher stops after filling with water

Tekst:

My dishwasher stops running after it brings hot water in at the very beginning. Sometimes, it will start and stop various times (I suppose, continuing on through consecutive stages, but I can't be sure what it's actually doing because it rarely ends with clean dishes) across many hours. Other times, it never gets past this initial intro stage.

A few times in the past, I had success at cutting the power at the breaker, and then it tended to work perfectly for a handful of times afterwards before it would start acting up again. This last time I tried to cut breaker, however, was unsuccessful, and now it won't get past that first stage (which I always have to hit cancel to drain the water, which luckily still works every time). --Funny but not, I broke the breaker switch flipping it too many times, so I had to replace that today.--

By the way, it opens the soap tab after 5 or 10 minutes, even if it's not running/washing. So, some aspects of the "wash" cycle are working, I guess.

All panel lights are working and displaying on top.

Whirlpool Gold

Model: Wdt710paym

Only 3 years old.

Thanks for any help!

Apparaat:

Dishwasher

Status:

open

Goedgekeurd antwoord:

456568

Origineel bericht door: radicalng8 ,

Titel:

Whirlpool Dishwasher stops after filling with water

Tekst:

My dishwasher stops running after it brings hot water in at the very beginning. Sometimes, it will start and stop various times (I suppose, continuing on through consecutive stages, but I can't be sure what it's actually doing because it rarely ends with clean dishes) across many hours. Other times, it never gets past this initial intro stage.

A few times in the past, I had success at cutting the power at the breaker, and then it tended to work perfectly for a handful of times afterwards before it would start acting up again. This last time I tried to cut breaker, however, was unsuccessful, and now it won't get past that first stage (which I always have to hit cancel to drain the water, which luckily still works every time). --Funny but not, I broke the breaker switch flipping it too many times, so I had to replace that today.--

By the way, it opens the soap tab after 5 or 10 minutes, even if it's not running/washing. So, some aspects of the "wash" cycle are working, I guess.

All panel lights are working and displaying on top.

Whirlpool Gold

Model: Wdt710paym

Only 3 years old.

Thanks for any help!

Apparaat:

Dishwasher

Status:

open