Ga door naar hoofdinhoud
Help

Origineel bericht door: Michael Behan ,

Tekst:

Hello Gerald,

1. Open the scanner and top lid with the power on to move the printer head to the middle of the carriage.

2. Unplug from power. Pull the top end of the strut which props the lid up on the right side towards the front of the printer to disconnect it from the scanner. You may need to pry it off with a small screwdriver.

3. Remove 7 black torx screws holding the top panel of the printer. One of these is hidden behind the HP label at the right front corner of the printer. Peel the label half way to expose it.

4. Carefully pry the LCD control panel off the top panel with a screwdriver. Disconnect the ribbon cable. Just pull it straight out. Remove a further two silver torx screws hidden behind the control panel.

5. The top printer panel should now be free to remove.

6. Look down inside the right side of the printer casing near where the printheads usually park with a good light. There are two channels containing sponge saturated with thick ink- the ''waste ink sponges''. These are not readily removed. Poke the sponge with a small screwdriver to show the ink.

7. With a syringe and a long blunt needle from an ink cartridge refilling kit, suck up as much ink as possible from the two sponges. Mop up any ink in the interior of the printer.

8. Re-assemble the printer.

Status:

open