Ga door naar hoofdinhoud
Help

Origineel bericht door: Marc ,

Tekst:

josephcreveling ,

The unit should go back to sleep in a few seconds by itself since it sounds like you already have the digi disconnected. If you are just replacing the digi glass it won't matter. I have done many of them without failure both on and off. You have to connect the plug before you snap the mid frame bezel and glass back into place and if you are worried about it you can plug it in, hold the off button until the red slide comes up and slide it to the right, wait a few seconds and then snap it in. Shouldn't matter though. If you were replacing the battery that is a different story.

Status:

open