Ga door naar hoofdinhoud
Help

Origineel bericht door: Cmd ,

Tekst:

I did this back when I first started soldering on an IBM motherboard Security chip. I never was able to fix it but you can attempt to either scrap the traces it normally connected to and attempt to solder to them, or follow the traces to where it meets up with something and hope the something is large enough to be easy to solder to. Very good eyes and soldering skills are required, also a multimeter can help a lot also.

Good Luck!

Worse case, throw it on ebay, if I saw one on there for cheap enough I would buy it just to try :D.

Status:

open