Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie



Origineel bericht door: Dan ,


Sadly I suspect your heat sink is bad. You'll need to change it as well as clean & apply fresh thermal paste.

if you do a careful inspection you'll likely see some wetness near the heat transfer tube on the logic board or you'll see a pin hole in the tube.

If you have access to a non contact thermometer or FLER scope you can see the heat is not transferring to the fins.

Once you get the new heat sink with a good digital scale you'll note the bad unit will be slightly lighter than the new unit.