Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: Errol ,

Titel:

Thermal Pads vs Arctic Silver

Tekst:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

Apparaat:

PowerBook G4 Aluminum 15" 1-1.5 GHz

Status:

open

Goedgekeurd antwoord:

44304

Bewerkt door: David Hodson ,

Titel:

Thermal Pads vs Arctic Silver

Tekst:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

Apparaat:

PowerbookPowerBook G4 FW800Aluminum 15" 1-1.5 GHz
PowerbookPowerBook G4 FW800Aluminum 15" 1-1.5 GHz

Status:

open

Origineel bericht door: Errol ,

Titel:

Thermal Pads vs Arctic Silver

Tekst:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

Apparaat:

Powerbook G4 FW800

Status:

open