Ga door naar hoofdinhoud
Help

Deze versie is geschreven door: oldturkey03 ,

Tekst:

stuart, here is what the service manual suggest :
Open the oven door as wide as possible.
+
Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1,
+
Remove the screws from each side with a Phillips screwdriver.
+
Remove the lock plate from each side, Figure 2-1
+
Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin.
+
Grasp the door toward the top on both sides. Lift the door up and out to remove.
-[image|212626]
+[image|212626|align=center]
"SERVICING OVEN DOOR
1. Lay the oven door on a protected surface with the inner door panel facing down.
2. Remove three screws from lower trim.Remove trim piece.
3. Slide outer-door glass down to disengage from top trim. Remove.
4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.
5. Lift up and off. This will disengage the side trim as well.
6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."
Hope this helps, good luck.

Status:

open

Bewerkt door: oldturkey03 ,

Tekst:

stuart, here is what the service manual suggest :
+
+Open the oven door as wide as possible.
+Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1,
+Remove the screws from each side with a Phillips screwdriver.
+Remove the lock plate from each side, Figure 2-1
+Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin.
+Grasp the door toward the top on both sides. Lift the door up and out to remove.
+
+[image|212626]
"SERVICING OVEN DOOR
1. Lay the oven door on a protected surface with the inner door panel facing down.
2. Remove three screws from lower trim.Remove trim piece.
3. Slide outer-door glass down to disengage from top trim. Remove.
4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.
5. Lift up and off. This will disengage the side trim as well.
6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."
Hope this helps, good luck.

Status:

open

Origineel bericht door: oldturkey03 ,

Tekst:

stuart, here is what the service manual suggest :

"SERVICING OVEN DOOR

1. Lay the oven door on a protected surface with the inner door panel facing down.

2. Remove three screws from lower trim.Remove trim piece.

3. Slide outer-door glass down to disengage from top trim. Remove.

4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.

5. Lift up and off. This will disengage the side trim as well.

6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."

Hope this helps, good luck.

Status:

open