⟐ Commented februari 07, 2017 at 14:25 MST

⟐ Commented december 23, 2016 at 11:49 MST

⟐ Answer edited december 02, 2016 at 22:15 MST

⟐ Answered november 19, 2016 at 22:26 MST

I've tried using gravity as I unscrew it.

I've tried pushing the screen toward the back. I've pried the side without the screw up.

I tried finding something sticky to put on the driver, like putty, but to no avail.

I've even, hold on to your shorts, put some superglue on the tip of the driver to pull it out.

What next?

Rodney

⟐ Commented oktober 13, 2016 at 4:54 MST

⟐ Commented augustus 17, 2016 at 17:53 MST

⟐ Commented augustus 15, 2016 at 10:31 MST

⟐ Commented juli 25, 2016 at 13:11 MST

⟐ Commented juni 20, 2016 at 14:15 MST

Received a Iphone 5C that a customer wanted to change the screen on, nothing unusual..

First thing I noticed was the water sensor on the back of the LCD was a little pink. I switched over the parts and put on the new screen and everything seemed to work fine.

Then, 2-3minutes later of testing the screen started acting very erratic. It was extremely sensitive to the point where I could use an app without even touching the screen (simply hover my finger directly over the screen resulted in the app starting up)

I've switched out the screen 4-5times now, sadly I don't have another unit to test the screens with though. However I'd also like to point out that the 2 of the screens are from a different batch. So I can't imagine the problem being screen.

Any ideas? I tend to only restore the phone as a last result thing..

⟐ Commented juni 19, 2016 at 6:12 MST

I replaced the screen as advised and at first it was much better as only one small spot on the screen was unresponsive and there was no jumping around. However, after 1-2 weeks it is now worse than it originally was. When the screen is touched it jumps almost every time (i.e. if I click on a message it acts as if I swiped it to delete or if I touch an email it won't open and the screen will jump up and down).

⟐ Commented mei 01, 2016 at 22:00 MST

⟐ Answered april 02, 2016 at 8:13 MST

I'm going to be replacing my screen anyways, so I thought it might be a good opportunity to replace the microphone. But I can't find parts or a guide for such on here. Is it included in another set of parts or something? What can I do?

⟐ Answered maart 28, 2016 at 2:03 MST

Is there another way to remove that's easier and cheaper

⟐ Commented februari 25, 2016 at 5:00 MST

I took the iPhone apart to find the battery all wrinkled up as if it's been soaked in water and it was very flimsy to the point where I would be been able to snap it in half effortlessly. I replaced the battery, and now this part is working. I identified this by plugging the iPhone into my Mac which opened up iTunes and Photos.

So my Mac can see the iPhone perfectly fine, comes up in Photos displaying the photos on the iPhone, but there aren't any to display anyway. Comes up in iTunes asking if I want to allow this computer to access information on this IPhone. I select continue and it prompts me to accept on the iPhone screen, obviously the screen isn't working so I can't get any further at this point.

I tried the screen it came with, with the new battery but no luck. I don't currently have a replacement screen to try, but I did have a look at the connectors under a magnifying glass on the existing display assembly (bar the camera, sensor and home button). I noticed the odd one or two damaged pins; perhaps more couldn't tell for sure with this strength of magnification. Now, working in PC repair where things are bigger and less delicate, such little damage to the connectors makes me think it's not that. But my question is how damaged do they need to be to cause the screen to not function?

It should also be noted that a few brackets and almost all screws are missing, so components like the lighting connector, speaker and headphone jack are all loose. Although because I can get the iPhone to,come up in iTunes I don't think it matters too much.

⟐ Commented januari 09, 2016 at 14:46 MST

I don't want to buy any off of eBay because I know they'll all be a load of rubbish. I've seen some decent ones on Amazon with more reliable branding but I was ideally hoping to get Apple original parts if possible. Also, I'm not looking for anything too expensive as I still need to make a profit on my repairs.

Anyone have advice on this?

Thanks very much.

⟐ Answer accepted januari 07, 2016 at 16:08 MST

Please help

Mike.

⟐ Commented december 27, 2015 at 12:40 MST

I have this stubborn iPhone 5c which I can not get the home button to function. I have replaced both the button and the charging port twice to no avail. Even ios restore. Does anyone have knowledge of this issue?

⟐ Answered december 08, 2015 at 14:23 MST

I can still talk to people if I use the speaker mode. Siri can also hear me it appears that it's only during calls that no one else can hear me. I also tried testing it in voice memos and the microphone doesn't pick anything up.

Can anyone shed some light on this for me on what could have gone wrong? I know the microphone is part of the lighting connector assembly however I never touched that part/area while I swapped the battery.

Thanks!

⟐ Commented november 23, 2015 at 7:39 MST

I replaced the screen on this broke iphoone 5c. It now looks like the pictures above and is getting a little hot in the upper right corner (on the back where the digitizer and screen connects). I need some help on how to fix it.

Thanks,

David

⟐ Commented oktober 05, 2015 at 12:17 MST