iFixit - Answers With Device "HVAC"

Dyson DP01: Na het schoonmaken van het filter gaat de machine niet meer aan.

Sun, 16 Nov 2025 02:10:33 -0700

Op dezelfde manier uit en in elkaar gezet maar hij wil met geen mogelijkheid meer aan.

Idee wat er aan de hand kan zijn?

⟐ Answered november 16, 2025 at 2:10 MST

Ceiling fan: MSC MS42 Mjjn motorschakelaartje was stuk en heb een nieuwe gekocht

Mon, 21 Apr 2025 07:31:27 -0700

ik weet niet welke kleur waar moet zitten 3 draads

⟐ Commented april 21, 2025 at 7:31 MST

Air Conditioning: LCD backlight toevoegen aan remote control

Mon, 03 Aug 2020 15:07:26 -0700

Ik wil LCD backlight toevoegen aan een bestaande remote control (daikin ARC433A) zonder backlight. Ik heb 2x1,5V AAA en weinig plaats beschikbaar. Zou enkel licht willen als ik op een knop van de remote control duw (‘s nachts in bed). Ik ben op zoek naar een link die mij in de goede richting zet.

⟐ Answered augustus 03, 2020 at 15:07 MST

HVAC: hoe kan ik een thermostaatkraan vervangen

Wed, 19 Nov 2014 20:57:44 -0700

LS,

Ik wil de thermostaatkraan van een grohe pharo lift douchepaneel vervangen.

Ik zit al een poosje te googlen naar een oplossing maar het model wat ik zoek schijnt verouderd te zijn en ik kan hier niets over vinden?

English:

I want to replace the thermostat with a Grohe shower panel pharo lift.

I'm already googling for a while for a solution but the model I seem to find are outdated and I can not find anything about this?

⟐ Edited november 19, 2014 at 20:57 MST

Challenge 10l dehumidifier: Why is my dehumidifier collecting water in the air filter not the draw

Tue, 14 Jul 2026 03:09:44 -0700

My dehumidifier has not been collecting water in the drawer. I have just taken the filter off to have a look and noticed water in the back. Is there anything I can do about this? I can’t find any blockages to the water to drawer.

It is the Challenge 10l dehumidifier MDDN-10DEN7-QA3

⟐ Commented juli 14, 2026 at 3:09 MST

Samsung Air Conditioner: Outdoor fan is not working

Sun, 12 Jul 2026 10:34:33 -0700

The outdoor fan is not working but indoor is working

⟐ Answered juli 12, 2026 at 10:34 MST

LG LWHD800R: Remote is working properly but not supported by AC unit

Fri, 10 Jul 2026 23:39:21 -0700

Remote is working properly but not supported by AC unit

⟐ Answered juli 10, 2026 at 23:39 MST

Dehumidifier: it No keep water

Thu, 09 Jul 2026 03:01:02 -0700

No keep water

⟐ Commented juli 09, 2026 at 3:01 MST

Dehumidifier: E9 error code on Noma dehumidifier

Thu, 09 Jul 2026 02:38:23 -0700

How to fix an E9 error code on a Noma dehumidifier. I think I need to replace the sensor

⟐ Answered juli 09, 2026 at 2:38 MST

Beko BKK 1600P Stand Fan: fan motor is not rotating

Sat, 04 Jul 2026 01:20:44 -0700

why my fan motor is not working rotating

Holmes 16 Inch 4-in-1 Fan: Why the fan does not spin

Sat, 04 Jul 2026 00:26:18 -0700

When I swith o the fan it only makes noise but the blade does not spin

⟐ Commented juli 04, 2026 at 0:26 MST

Dyson am09 hot cool heater fan: Fan Wont power on - part blown

Fri, 03 Jul 2026 11:44:26 -0700

Hi There!
My fan is no longer powering on and from taking it apart as best I can it looks like one of the chips has blown although i'm struggling to identify the part to attempt replacement, does anyone know what this part may be?

⟐ Answer accepted juli 03, 2026 at 11:44 MST

Beko BKK 1600P Stand Fan: My fan's mortar runs very slowly and heats up very quickly.

Fri, 03 Jul 2026 06:22:15 -0700

My fan's mortar runs very slowly and heats up very quickly.

⟐ Answered juli 03, 2026 at 6:22 MST

Dyson AM07 Tower Fan: faulty fan now board dead

Thu, 02 Jul 2026 03:51:16 -0700

So i have just replaced the oscillating motor and the x2 cap to fix the side to side movement and stop it happening when it's off! the main fan motor was a bit noisy, so i decided to take the impeller off the motor and clean and lube the bearings...bad idea! the impeller ended up breaking the locating lugs off the bottom of it, and after all the messing around, when i turned it all back on, the motor was really unhappy, causing surges and then cutting out completely. tested the fan from a known good machine and it worked for half an hour continuously at 10 without any issue...

I managed to source a second hand unit from a dyson repair shop nearby, and it arrived today - plugged it in, the display came on, motor did nothing...seconds later the screen went dark and nothing worked since. i've since tested the motor, and it seems to have a short/very low resistance between the case and W1 phase wire - obviously it's sent 300v upstream and done some damage!

I've checked the fuse, all the 0ohm resistors i can find, and run through a load of testing with the help of AI to prove the buck regulator, the mosfets and the driver ICs all seem to be behaving as expected. however, after tracing U2 (5v regulator), it seems to have a direct short to ground on 2 pins. from what i can find, it appears pin 1 is output (apart from anywhere else, it supplied voltage to the screen), pin 2 gnd and ping 3 input - which appears to have a direct connection to the buck regulator IC output. thinking the 5v regulator had gone short, i pulled it.....and still have the short. then i removed cap c7 to make sure that wasn't shorting....it wasn't either.

Literally tearing my hair out now (shop said they wouldn't replace the damaged board, but have agreed a 50/50 split on a new board if i have to; but I would rather fix this.

Can anyone offer any advice? any common failures when the motors go short?

Thanks all!

⟐ Commented juli 02, 2026 at 3:51 MST

LG LWHD1006R: Why is the cooling water not falling and it’s not also cooling.

Tue, 30 Jun 2026 04:22:10 -0700

Making noise, not cooling and the outdoor not dropping water.

⟐ Commented juni 30, 2026 at 4:22 MST

Intertek Clip Fan 0610: How to open my fan from motor and blade

Mon, 29 Jun 2026 01:15:19 -0700

How to open my fan from motor

⟐ Answered juni 29, 2026 at 1:15 MST

Air Conditioning: Trying to source a suitable air-con

Thu, 25 Jun 2026 16:11:13 -0700

Last year, during the heatwave, I invested in an air conditioner unit, which gave me about 2 weeks of blissful cool conditions until the electrics burnt out. I was able to send the unit back to Amazon and get a replacement under warranty.

Sadly, the replacement packed up after 2 weeks. This time I was unable to get it replaced under warranty, because it was deemed to have been used in an unsuitable way, with the exhaust pipe having to have both a steep rise and a sharp turn to get out of the window. This left me out of pocket to the order of about £600.

It turns out that the geometry of the window in my flat could not have been made any more air-con unfriendly, even if it had been deliberately designed as such!

The height of the window, and the fact that the window is hinged at the top, makes it virtually impossible to have an exhaust pipe that will work without overloading the air-conditioner.

My question is what advise would you give to provide a solution that would suit my window?

Toule Sauna Heater: Sauna wouldn’t engage after temperature is set

Thu, 25 Jun 2026 16:02:30 -0700

Why the sauna keep going back in a loop after the desired temperature and time is set and wouldn’t start heating.

⟐ Commented juni 25, 2026 at 16:02 MST

Holmes tower fan: My fan on rotates for less than a second and off automatically

Tue, 16 Jun 2026 20:06:37 -0700

My fan on rotates for less than a second and off automatically

Delonghi portable upright air conditioner: How to remove the drain pan

Tue, 16 Jun 2026 07:48:50 -0700

How to remove the drain pan

⟐ Commented juni 16, 2026 at 7:48 MST